Thank you for choosing H₂Pro Dental Water Line Treatment for your office. H₂Pro has been specially formulated and clinically proven to control odor-causing bacteria and clean dental unit waterlines. It is the FIRST product approved by the EPA for continuous use in dental units. It is designed for closed systems with self contained water bottles only.

The Clean Start™ treatment, with colloidal silver and hydrogen peroxide, is designed to power through accumulated build up. The Maintenance Treatment contains a controlled, minute amount of colloidal silver to keep things clean.

Our special formulation gives you peace of mind knowing that you are using the best possible product for your patients. This is all accomplished without adding any taste or scent to your treatment water, without any adverse affects to bond strength, while treating your sensitive equipment as mildly as distilled water.

Use of the following Clean Start™ process will give you the best, most rapid results.

STEP 1: For best results begin the Clean Start™ treatment at the end of the last business day of the week for your office.

IMPORTANT!!! Do not treat patients with the red Clean Start™ solution!

1. After treating the last patient of the day, remove the water bottle from the dental chair to be treated and completely empty it.
2. Pour the entire contents of both H₂Pro Clean Start™ Bottles A and B (red labels) into the emptied water bottle.
3. Reattach the water bottle to the chair and run all lines attached to the dental chair until the red coloration of the treatment solution appears exiting the lines.
4. For best results allow the lines to sit unused for a minimum of 12 hours.
5. Prior to returning the chair to patient use, remove the water bottle from the treated chair and completely drain remaining Clean Start™ Treatment solution from lines and the bottle - begin step 2. (Discard solution accordingly)

Re-treatment parameters: Proper H₂Pro Clean Start™ treatment followed by continuous use of Maintenance Treatment solution should be adequate to keep your lines clean. If there is a return of noticeable odor or if there appears to be any debris in the dental water effluent, re-treatment with Clean Start is indicated. Part #HPCS1

STEP 2: Begin H₂Pro ™ Maintenance Treatment now to keep your lines clean. Preparation and use of H₂Pro Maintenance Treatment

1. Pour the entire contents of one (1) H₂Pro Maintenance Treatment bottle (Blue label) into the 1 gallon dispensing container provided.
2. Add one (1) US gallon (3.785 liters) of distilled¹ or deionized¹ water (32:1 dilution) to the fill line indicated on the dispenser container.
3. Fill the dental chair water bottle with the prepared Maintenance Treatment from the dispensing container and reattach the water bottle to the chair. (For added convenience, keep a dispenser with prepared Maintenance Treatment in each operatory for quick refills.)
4. Run all lines attached to the dental chair until the blue coloration of the Maintenance Treatment can be seen exiting the lines.
5. The dental chair is now ready for patient use.
6. Use prepared H₂Pro Maintenance Treatment continuously in the dental chair instead of distilled, deionized or tap water.

¹ Use of tap water or bottled "Drinking" or "Spring" water is not recommended. Water quality from these sources varies and your results with H₂Pro may vary accordingly.